Flow Inducer Towers (FIT)

Flow Inducer Towers manufactured by Orenco® are used to house two to five Orenco high-head effluent pumps in recirculation tanks or final discharge tanks following filtration or secondary treatment in commercial and municipal wastewater systems. For tanks with curved bottoms, an Orenco vault basin is required to create a flat surface on which the flow inducer tower can rest. Flow inducer towers include a float bracket for attaching an Orenco float switch assembly (ordered separately).

  • Fiberglass structural plates and tower base
  • PVC flow inducer tubes and float bracket
  • Schedule 80 PVC support pipes.
  • Models available to house two, three, four, or five 4-inch (100-mm) high-head effluent pumps
  • Recirculation or discharge tank models available
  • Eight inlet holes per flow inducer tube
  • 2-inch (50-mm) inlet hole diameter
  • 19¼-inch (483-mm) inlet hole height for recirculation tank models
  • 9-inch (229-mm) inlet hole height for discharge tank models

 

Sample Product Codes*

  • FITR-D102 — flow inducer tower, recirculation tank; duplex towers;
    102-inch (2590-mm) tower height
  • FITR-Q126 — flow inducer tower, recirculation tank; quad towers;
    126-inch (3200-mm) tower height
  • FITD-D102 — flow inducer tower, discharge tank; duplex towers;
    102-inch (2590-mm) tower height
  • FITD-Q126 — flow inducer tower, discharge tank; quad towers;
    126-inch (3200-mm) tower height
  • VB1806-FRP — vault basin for rounded tanks
     

* For the full range of available product options, contact your local Orenco Distributor or Orenco.
 


Technical Data Sheet

Orenco Flow Inducer Tower